OLED 0.96" modul for Arduino

Feature:

 

Control chip: SSD1306

Display area: 21.744 x 10864mm

Physical size: 27.3 x 27.8mm

Interface type: Default 4-wire SPI

Switchable rear resistor to use 3-wire SPI, IIC interfaces

Number of pins: 7

Display color: yellow blue

Working temperature: -40~70°C

Net weight: 5g

 

Interface definition:

 

1> GND (Power ground)

2> VCC (Power + 3.3-5V)

3> D0 (SPI clock line for SPI interface and IIC clock line for IIC interface)

4> D1 (SPI data line for SPI interface and IIC data line for IIC interface)

5> RES (OLED reset, OLED needs to be reset once after power-on)

6> DC (SPI data/command selection pin, used to set IIC address when IIC interface)

7> CS (OLED SPI chip select, active low, if you do not want to use must be grounded)

 

Package includes:

 

1 x 0.96 Inch OLED Display Module

 

Wiring method:

 

Wiring 1:

MCU hardware SPI connection method:

If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO.

 

Wiring 2:

MCU IO analog SPI connection mode:

If there is only one device on the SPI bus, you can directly ground the CS of the OLED screen, which saves an IO.

 

Wiring 3:

MCU analog IIC connection method:

IIC address:

DC is low = 0x78

DC is high = 0x7A

Generally DC grounding

 

Wiring 4:

MCU hardware IIC connection method:

IIC address:

DC is low = 0x78

DC is high = 0x7A

Generally DC grounding

OBS! Dette produktet blir sendt direkte fra leverandør. Du må derfor beregne en del lengre leveringstid.

Til gjengjeld spanderer vi frakten.